2.2

Knobs and switches

It is easy to control the parameters with the large round knobs and switches. They will light up when you move the mouse cursor around to indicate that you can adjust them. The moment you move the mouse cursor over a knob, a parameter value display will pop up, which shows the current value of the parameter.

All knobs support two click-and-drag modes:

1. Vertical mode
   Click on the center area of a knob and drag up or down to rotate it. This is particularly useful for quick changes, but you can also hold down the Shift key while dragging to make precise adjustments.
   
2. Rotate mode
   Grab the arrow of the knob and drag it around. By moving the mouse cursor further away from the knob while dragging it, you can adjust the knob very precisely.

To change the position of a switch, simply drag the switch thumb up or down, or click at the new position.

Tips

• To reset a knob to its default position, hold down the Ctrl key (Windows) or Command key (OS X) and click the knob once.
• The knobs that control frequency and peak for both filters can be linked to each other. To adjust both parameters, hold down the Alt key while dragging one of the knobs.
• Pro Tools note: the RTAS version of the plug-in implements the default Pro Tools key short cuts for fine tune (Ctrl+click on Windows, Command+click on OS X), linked change (Shift+click) and reset to default (Alt+click).

Next: Filters

See Also
Overview